Get Started FCSS_NST_SE-7.4 Exam [2026] Dumps Fortinet PDF Questions [Q27-Q48]

NEW QUESTION 27
Refer to the exhibit, which contains the output ofdiagnose vpn tunnellist.

Which command will capture ESP traffic for the VPN named DialUp_0?

diagnose sniffer packet any ‘ip proto 50’

diagnose sniffer packet any ‘host 10.0.10.10’

diagnose sniffer packet any ‘esp and host 10.200.3.2’

diagnose sniffer packet any ‘port 4500’

NEW QUESTION 28
Refer to the exhibit, which shows the output o! the BGP database.

Which two statements are correct? (Choose two.)

The advertised prefix of 10.20.30.0’24 was configured using the network command.

The first four prefixes are being advertised using a legacy route advertisement.

The advertised prefix of 10.20.30.0’24 is being advertised through the redistribution of another routing protocol.

The output shows all prefixes advertised by all neighbors as well as the local router.

NEW QUESTION 29
Which of the following regarding protocol states is true?

proto_state=10indicates an established TCP session.

proto_state=00indicates that UDP traffic flows in both directions.

proto_state=01indicates one-way ICMP traffic.

proto_state=01indicates an established TCP session.

NEW QUESTION 30
Refer to the exhibit, which contains the output of the command diagnose vpn tunnel list.

Reviewing the debug command, what is the current status of the traffic flowing through the tunnel?

Traffic is flowing with an asymmetric selector.

There is an unsupported cipher or HMAC

The inbound IPsec SA was copied to the NPU.

The outbound IPsec SA was copied to the NPU.

NEW QUESTION 31
Refer to the exhibit, which shows a session table entry.

Which statement about FortiGate behavior relating to this session is correct?

FortiGate redirected the client to the captive portal to authenticate, so that a correct policy match could be made.

FortiGate forwarded this session without any inspection.

FortiGate is performing a security profile inspection using the CPU.

FortiGate applied only IPS inspection to this session.

NEW QUESTION 32
Exhibit.

Refer to the exhibit, which shows the output of a diagnose command.
What can you conclude about the debug output in this scenario?

The first server provided to FortiGate when it performed a DNS query looking for a list of rating servers, was 121.111.236.179.

There is a natural correlation between the value in the FortiGuard-requests field and the value in the Weight field.

FortiGate used 64.26.151.37 as the initial server to validate its contract.

Servers with a negative TZ value are less preferred for rating requests.

NEW QUESTION 33
Refer to the exhibit, which shows the omitted output of a session table entry.

Which two statements are true? (Choose two.)

The traffic has been tagged for VLAN 0000.

NP7 is handling offloading of this session.

The traffic matches Policy ID 1.

The session has been offloaded.

NEW QUESTION 34
Refer to the exhibit, which shows a partial output of the fssod daemon real-time debug command.

What two conclusions can you draw Itom the output? (Choose two.)

The workstation with IP 10.124.2.90 will be polled frequently using TCP port 445 to see if the user is still logged on.

The logon event can be seen on the collector agent installed on Windows.

FSSO is using DC agent mode to detect logon events.

FSSO is using agentless polling mode to detect logon events.

NEW QUESTION 35
Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

Strict RPF is enabled by default.

User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.

User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.

User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.

User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.

NEW QUESTION 36
Which two statements are true regarding heartbeat messages sent from an FSSO collector agent to FortiGate? (Choose two.)

The heartbeat messages can be seen using the command diagnose debug authd fsso list.

The heartbeat messages can be seen in the collector agent logs.

The heartbeat messages can be seen on FortiGate using the real-lime FSSO debug.

The heartbeat messages must be manually enabled on FortiGate.

NEW QUESTION 37
Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

The administrator must also run the command diagnose debug enable.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

NEW QUESTION 38
What are two reasons that an OSPF router does not have any type 5 link-state advertisements (LSAs) in its link-state database (LSDB)? (Choose two.)

The local router is located in a stub area.

IP protocol 89 is blocked between the local router and its peer.

There is no autonomous system border router (ASBR) in the network.

The peer of the local router is using a prefix-list-outconfiguration to prevent all type 5 LSAs to be advertised.

NEW QUESTION 39
Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

The administrator must also run the command diagnose debug enable.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

NEW QUESTION 40
Refer to the exhibit, which shows the output o! the BGP database.

Which two statements are correct? (Choose two.)

The advertised prefix of 10.20.30.0’24 was configured using the network command.

The first four prefixes are being advertised using a legacy route advertisement.

The advertised prefix of 10.20.30.0’24 is being advertised through the redistribution of another routing protocol.

The output shows all prefixes advertised by all neighbors as well as the local router.

NEW QUESTION 41
What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow?
(Choose two.)

Packet was dropped because of policy route misconfiguration.

Packet was dropped because of traffic shaping.

Trusted host list misconfiguration.

VIP or IP pool misconfiguration.

NEW QUESTION 42
In an FSSO environment, a user is listed as active on FortiGate but cannot browse the internet.
Which factor do you not need to verify as a potential problem?

The connectivity between the collector agent and FortiGate

Whether there is a valid firewall policy

The user’s group information

That the user’s IP address is in the list of active FSSO users

NEW QUESTION 43
Exhibit.

Refer to the exhibit, which shows a partial web fillet profile configuration.
Which action does FortiGate lake if a user attempts to access www. dropbox. com, which is categorized as File Sharing and Storage?

FortiGate allows the connection, based on the URL Filter configuration.

FortiGate blocks the connection as an invalid URL.

FortiGate exempts the connection, based on the Web Content Filter configuration.

FortiGate blocks the connection, based on the FortiGuard category based filter configuration.

NEW QUESTION 44
Refer to the exhibit, which shows a partial output of the fssod daemon real-time debug command.

What two conclusions can you draw Itom the output? (Choose two.)

The workstation with IP 10.124.2.90 will be polled frequently using TCP port 445 to see if the user is still logged on.

The logon event can be seen on the collector agent installed on Windows.

FSSO is using DC agent mode to detect logon events.

FSSO is using agentless polling mode to detect logon events.

NEW QUESTION 45
Refer to the exhibit, which shows partial outputs from two routing debug commands.

Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?

Set snat-route-change to enable.

Set the priority of the static default route using port2 to 1.

Set preserve-session-route to enable.

Set the priority of the static default route using port1 to 10.

NEW QUESTION 46
Which actions does FortiGate take after an administrator enables the auxiliary session setting?
(Choose two.)

FortiGates creates a new auxiliary session for each packet it receives.

FortiGate only offloads auxiliary sessions.

FortiGate creates two sessions in case of a routing change.

FortiGate accelerates all ECMP traffic to the NP6 processor.

NEW QUESTION 47
Refer to the exhibit. Which three pieces of information does the diagnose sys top command provide? (Choose three.)

The miglogd daemon is running on CPU core ID 0.

The diagnose sys top command has been running for 18 minutes.

The miglogd daemon would be on top of the list, if the administrator pressed m on the keyboard.

The cmdbsvr process is occupying 2.4% of the total user memory space.

If the neweli daemon continues to be in the R state, it will need to be manually restarted.

NEW QUESTION 48
Refer to the exhibit, which shows the output of a diagnose command.

The administrator did not override the FortiGuard FQDN or IP address in the FortiGate configuration.
Which IP address did FortiGate get when resolving the service.fortiguard.net name?

121.111.236.179

209.22.147.36

208.91.112.194

64.26.151.37

admin

You May Also Like

Leave a Reply Cancel reply