NSE7_EFW-7.2 Training & Certification Get Latest NSE 7 Network Security Architect Updated on Jan 04, 2026 [Q25-Q42]

Rate this post

NSE7_EFW-7.2 Training & Certification Get Latest NSE 7 Network Security Architect Updated on Jan 04, 2026

Certification Training for NSE7_EFW-7.2 Exam Dumps Test Engine

Fortinet NSE7_EFW-7.2 Exam Syllabus Topics:

Topic	Details
Topic 1	VPN: Implementing IPsec VPN IKE version 2 is discussed in this topic. Additionally, it delves into implementing auto-discovery VPN (ADVPN) to enable on-demand VPN tunnels between sites.
Topic 2	System configuration: This topic discusses Fortinet Security Fabric and hardware acceleration. Furthermore, it delves into configuring various operation modes for an HA cluster.
Topic 3	Security profiles: Using FortiManager as a local FortiGuard server is discussed in this topic. Moreover, it delves into configuring web filtering, application control, and the intrusion prevention system (IPS) in an enterprise network.
Topic 4	Routing: It covers implementing OSPF to route enterprise traffic and Border Gateway Protocol (BGP) to route enterprise traffic.
Topic 5	Central management: The topic of Central management covers implementing central management.

NEW QUESTION 25
Which two statements about IKE version 2 fragmentation are true? (Choose two.)

Only some IKE version 2 packets are considered fragmentable

The reassembly timeout default value is 30 seconds

It is performed at the IP layer

The maximum number of IKE version 2 fragments is 128

NEW QUESTION 26
An administrator has configured two fortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device What can the administrator do to fix this problem?

Verify that the speed and duplex settings match between me FortiGate interfaces and the connected switch ports

Configure remote Iink monitoring to detect an issue in the forwarding path

Configure set send-garp-on-failover enables under config system ha on both cluster members

Configure set link -failed signal enable under-config system ha on both Cluster members

NEW QUESTION 27
Refer to the exhibit, which shows device registration on FortiManager.

What can you conclude about the Spoke-1 and Spoke-2 configurations with respect to the information cond:
Modified (recent auto-updated)?

Based on the policy configuration on NGFW-1, the configuration on both spokes is modified and automatically updated.

On NGFW-A, the configuration was changed and spokes are wailing for an autoupdate.

On both Spoke-1 and Spoke-2, the configuration was changed directly on the FortiGate device, and the changes were automatically retrieved by the device database.

Spoke-1 and Spoke-2 are sharing the same security policy configuration and the same policy package.

NEW QUESTION 28
Refer to the exhibit, which shows config system central-management information.

Which setting must you configure for the web filtering feature to function?

Add server. fortiguard. net to the server list.

Configure securewf.fortiguard. net on the default servers.

Set update-server-location to automatic.

Configure server-type with the rating option.

NEW QUESTION 29
Refer to the exhibits, which contain the network topology and BGP configuration for a hub.
Exhibit A.

Exhibit B.

An administrator is trying to configure ADVPN with a hub and spoke VPN setup using iBGP. All the VPNs are up and connected to the hub. The hub is receiving route information from both spokes over iBGP; however the spokes are not receiving route information from each other.
What change must the administrator make to the hub BGP configuration so that the routes learned from one spoke are forwarded to the other spoke?

Configure the hub as a route reflector

Configure auto-discovery-sender on the hub

Add a prefix list to the hub that permits routes to be shared between the spokes

Enable route redistribution under config router bgp

NEW QUESTION 30
Which statement is true regarding the Bidirectional Forwarding Detection protocol in BGP?

BFD is only supported when two FortiGate devices are directly connected on the same network

BFD is using BGP keepalive messages to check the status of BGP peer

BFD is used to detect one way device failure

BFD is enabled under config router bfd configuration

NEW QUESTION 31
Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)

Set auto-discovery-sender enable

Set ike-version 2

Set auto-discovery-forwarder enable

Set auto-discovery-receiver enable

NEW QUESTION 32
Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

The router are in the number to match the remote peer.

You must change the AS number to match the remote peer.

BGP is attempting to establish a TCP connection with the BGP peer.

The bfd configuration to set to enable.

NEW QUESTION 33
Exhibit.

Refer to the exhibit, which contains an ADVPN network diagram and a partial BGP con figuration Which two parameters Should you configure in config neighbor range? (Choose two.)

set prefix 172.16.1.0 255.255.255.0

set route reflector-client enable

set neighbor-group advpn

set prefix 10.1.0 255.255.255.0

NEW QUESTION 34
Which two statements about the neighbor-group command are true? (Choose two.)

You can configure it on the GUI.

It applies common settings in an OSPF area.

It is combined with the neighbor-range parameter.

You can apply it in Internal BGP (IBGP) and External BGP (EBGP).

NEW QUESTION 35
Exhibit.

Refer to the exhibit, which shows an ADVPN network.
The client behind Spoke-1 generates traffic to the device located behind Spoke-2.
Which first message floes the hub send to Spoke-110 bring up the dynamic tunnel?

Shortcut query

Shortcut reply

Shortcut offer

Shortcut forward

NEW QUESTION 36
Which two statements about metadata variables are true? (Choose two.)

The metadata format is $<metadata_variable_name>.

You create them on FortiGate.

They can be used as variables in scripts.

They apply only to non-firewall objects.

NEW QUESTION 37
Refer to the exhibit which shows an OSPF network.

Which types of link-state advertisements (LSA) will NGFW-1 send if it is a backup designated router (BDR)

NGFW-1 will send type 1 and type 2 LSAs

NGFW-1 will send type 1 and type 4 LSAs.

NGFW-1 will send type 1 and type 3 LSAs

NGFW-1 will send type 1 and type 5 LSAs

NEW QUESTION 38
Refer to the exhibit, which shows an ADVPN network.

Which VPN phase 1 parameters must you configure on the hub for the ADVPN feature to function? (Choose two.)

set auto-discovery-forwarder enable

set add-route enable

set auto-discovery-receiver enable

set auto-discovery-sender enable

NEW QUESTION 39
After enabling IPS you receive feedback about traffic being dropped.
What could be the reason?

Fail-open is set to disable

Traffic-submit is set to disable

IPS is configured to monitor

Np-accel-mode is set to enable

NEW QUESTION 40
Exhibit.

Refer to the exhibit, which contains an active-active toad balancing scenario.
During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

Secondary physical MAC port1

Secondary virtual MAC port1

Secondary virtual MAC port1 then physical MAC port1

Secondary physical MAC port2 then virtual MAC port2

NEW QUESTION 41
Exhibit.

Refer to the exhibit, which shows a partial web filter profile conjuration What can you cone udo from this configuration about access to www.facebook, com, which is categorized as Social Networking?