2022 Realistic Verified Free Network Appliance NS0-176 Exam Questions [Q58-Q72]

Posted byadminJune 1, 2022Leave a Comment on 2022 Realistic Verified Free Network Appliance NS0-176 Exam Questions [Q58-Q72]

Rate this post

2022 Realistic Verified Free Network Appliance NS0-176 Exam Questions

NS0-176 Real Exam Questions and Answers FREE

NEW QUESTION 58
You run NetApp ConfigAdvisor against you FAS8060A storage system. The report states that the flow control settings for ports e0a on each node are incorrect.
Which set of commands will correct this problem?

network interface modify- node netapp-01 -port e0a -flowcontrol -admin none network interface modify -node netapp-02 -port e0a -flowcontrol – admin none

network interface modify- node netapp-01 port e0a-flowcontrol-admin full network interface modify- node netapp-02 port e0a-flowcontrol-admin full

network port modify -node netapp-01 -port e0a -flowcontrol-admin none network port modify -node netapp-02 -port e0a -flowcontrol-admin none

network port modify- node netapp-01 port e0a-flowcontrol-admin full network port modify- node netapp-02 port e0a-flowcontrol-admin full

NEW QUESTION 59
An administrator is configuring a Flexpod Datacenter solution. The UCS service profiles will use FCoE connectivity to the NetApp cluster.
Which pool is needed to configure the vHBA templates?

WWPN pool

MAC pool

IQN pool

WWNN pool

NEW QUESTION 60
Exhibit:

Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mode interface groups with autorevert set to true, hosting a single access LIF. NFS I/O is currently going through fabric A to ST-A. The customer wants to use both fabrics for NFS I/O.
In this scenario, what will accomplish this task?

Configure VMware hosts to use a new datastore with an NFS LIF on ST-B connected to fabric B.

Migrate the existing LIF that is used for NFS I/O on ST-A to its HA partner ST-B.

Add two physical links between SW-A and SW-B.

Configure VMware hosts to utilize an NFS LIF on ST-B that is connected to fabric A.

NEW QUESTION 61
Which is a valid connectivity option for a FlexPod?
Note some of these may also be ‘valid’ options outside of a FlexPod architecture but do not specifically meet FlexPod scalability and availability requirements.

UCS B-Series > 2232PP FEX > UCS FI > Nexus 5548 < FAS

UCS C-Series > 2232PP FEX > UCS FI > Nexus 5548 < FAS

UCS B-Series direct attach FAS

UCS C-Series > Nexus 3048 < FAS

UCS C-Series direct attach FAS

UCS B-series > UCS FI > 2232PP FEX > Nexus 5548 < FAS

UCS B-Series > UCS FI > Catalyst 3750 < FAS

NEW QUESTION 62
When connecting the Nexus 1110-X to the Nexus switch, what Spanning Tree port type is used?

Edge

Trunk

Network

Edge trunk

Normal

NEW QUESTION 63
While working on a performance related issue on your FlexPod solution, you notice an unequal distribution of traffic over the physical interfaces of a four port vPC between two Nexus 5000 switches. You would prefer a more even traffic distribution.
Which command would you use to accomplish this task?

~lacp rate fast~

~hardware multicast hw-hash~

~lacp system-priority~

~port-channel load-balance ethernet~

NEW QUESTION 64
Exhibit:

An iSCSI SAN boot is not working for a new Cisoc UCS service profile. The new vNIC template was created using the settings shown in the exhibit.
What should you do to make iSCSI SAN boot work?

Specify a QoS policy.

Change the MAC pool to “<not set>”.

Set the iSCSI-A-VLAN as the “Native VLAN”.

Change the vNIC template to type “Initial Template”.

NEW QUESTION 65
What management solution can provision all three components of a FlexPod (NetApp storage, Cisco UCS compute and Cisco Nexus network)?

Cisco UCS Central

Cisco FlexPod Manager

NetApp OnCommand Insight

Cisco UCS Director

NetApp FlexPod Manager

NEW QUESTION 66
Which feature allows Cisco Nexus 7000 Series switches to be virtualized at the device level?

PONG

VLAN

VRF

VDC

NEW QUESTION 67
You are asked to increase read performance for a single aggregate; however, there are no PCI-e slots available in the NetApp cluster nodes.
In this scenario, which feature meets these requirements?

Thin Provisioning

Flash Cache

Advanced Drive Partitioning

Flash pool

NEW QUESTION 68
Your UCS environment has recently been upgraded to include UCS B-Series Servers, UCS C-Series Servers, a UCS mini, and a fourth UCS domain. With these new changes, you need a management tool to help you manage the entire environment from a single location.
In this scenario, which tool would you use?

UCS Director

UCS Manager

UCS Central

Cisco Smart Advisor

NEW QUESTION 69
Exhibit:

Your vSphere host is booting off an SD and is displaying the error shown in the exhibit.
What should you do to correct the problem?

Enable Unified Extensible Firmware Interface (UEFI).

Enable SD card mirroring.

Update the current ESXi scratch location.

Reinstall ESXi on a larger SD card.

NEW QUESTION 70
How many VEMs can one server have?

unlimited

NEW QUESTION 71
With Clustered Data ONTAP, which three protocols are supported for host boot in a UCS stateless computing environment in the FlexPod configuration? (Choose three.)

CIFS

FCIP

FCoE

iFCP

iSCSI

NFS

NEW QUESTION 72
Exhibit:

You have FCoE configured between your Nexus 5672UP switches and UCS Fabric Interconnects running in FC end-host mode. You are experiencing disk I/O errors on your VMware FCoE datastore, but the NFS data stores on the same NetApp storage system are not exp eriencing any problems.
Referring to the Nexus output shown in the exhibit, what would cause this problem?