Best NACE-CIP2-001 Exam Dumps for the Preparation of Latest NACE-CIP2-001 Exam Questions [Q41-Q65]

Q41. You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

Q42. Coating surveys may include which steps?
Select All That Apply:

Q43. You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and you are asked to take DIY Film Thickness readings.
Your FIRST preferred course of action is to:

Q44. Cold-applied tape

Q45. Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

Q46. Inspection and Test plans are developed by referencing:

Q47. When using a destructive Paint Inspection Gauge the NACE inspector must:

Q48. A failure caused by applying a coating too thinly is known as

Q49. When observing design defects the NACE Inspector should:

Q50. The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

Q51. When ASIN D 3363 is specified the Inspector must:

Q52. You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

Q53. When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:

Q54. All of these are advantages of using repair patches EXCEPT

Q55. Generally for safety considerations, waterjetting hose connections use

Q56. When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:

Q57. You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

Q58. When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

Q59. WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

Q60. NACE Level 2 Inspectors have been authorized to perform:

Q61. Application of Thermal Spray Coatings requires:

Q62. As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

Q63. Galvanizing performs best in which of the following exposures:

Q64. NACE No.13/ SSPC 6 identifies the use of:

Q65. In the event of a conflict between the Product Data Sheet and the Specification: