Get Special Discount Offer of Senior-Internal-Corrosion-Technologist Certification Exam Sample Questions and Answers [Q21-Q40]

QUESTION 21
When NACE/SSPC W31 is referenced; what type of equipment would the Inspector expect to see on the job:

QUESTION 22
You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified. This is not a good choice because: >

QUESTION 23
Which standards are generally established by private-sector bodies and are available for use by any person or organization, private or government?

QUESTION 24
NACE/SSPC Water Jetting standards are directly equivalent to ISO Abrasive Blast Standards:

QUESTION 25
Non-Conformance Reports are designed to:

QUESTION 26
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 27
You ate the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no Individual gauge reading shall be below a certain value. As this is not part of the standard you should:

QUESTION 28
In the event of a conflict between the Product Data Sheet and the Specification:

QUESTION 29
Cold applied tape

QUESTION 30
Inspectors perform tests on linings that they may not perform on exterior coatings because

QUESTION 31
When observing design defects the NACE Inspector should:

QUESTION 32
When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

QUESTION 33
Antifouling coatings are regulated by international treaties.

QUESTION 34
Linings are used on the interior of pipelines to

QUESTION 35
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

QUESTION 36
When measuring the Dry Film Thickness of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument Is the:

QUESTION 37
You are a NACE Level 2 in-house inspector working in a shop. Your In-house UP requires you to perform a sleeve test to test for soluble sails; however the 3rd party NACE Level 3 inspector, representing the owner, has used a salt smart meter and has achieved a very different result and has rejected the pre cleaning.
Your FIRST preferred course of action is to:

QUESTION 38
Inspection and Test Plans are provided to:

QUESTION 39
The most likely area of failure on a buried external pipeline coating is the:

QUESTION 40
Inspection and Test plans are developed by referencing: