Latest HPE6-A86 Pass Guaranteed Exam Dumps with Accurate & Updated Questions [Q114-Q129]

NO.114 A Network Technician is installing a new HPE Aruba Networking CX switch and needs to connect it to the console port for initial configuration.
What type of physical port and cable are typically used for this direct, local management connection?

NO.115 In RSTP, how is the root bridge chosen in a network topology?

NO.116 Which load balancing algorithm typically uses source and destination IP addresses to determine traffic distribution in a LAG?

NO.117 Which layer of the network stack is responsible for CoS prioritization?

NO.118 What is the purpose of a routing table in IP networking, and how does it influence the forwarding of data packets?

NO.119 A Support Technician is remotely connected to an AOS-CX switch and needs to verify its serial number, the exact hardware model, and the installed firmware version before opening a support case. Which tools or commands can the technician use to quickly gather all of this essential information? (Choose 2.)

NO.120 A Network Operator is configuring VLANs on an HPE Aruba Networking CX switch to separate traffic for the Engineering (VLAN 10) and Sales (VLAN 20) departments. A user in the Engineering department connects their laptop to a port assigned to VLAN 20.
What will happen when the Engineering user’s laptop sends a broadcast frame, such as an ARP request?

NO.121 Which IEEE standard defines the Link Aggregation Control Protocol (LACP)?

NO.122 A Network Operator is managing a campus network with multiple HPE Aruba Networking CX switches. To ensure the ability to roll back to a known-good state before making significant changes, a checkpoint of the running configuration is created using the command `copy running- config checkpoint pre-change-01`. After making several configuration changes related to VLANs and routing, the operator discovers that the changes have caused network instability. They need to revert the switch to the exact state it was in before the changes were made.
Which command should the operator use to immediately restore the switch’s active configuration from the checkpoint?

NO.123 A junior network engineer is configuring a Network Management System (NMS) to monitor the health and performance of all switches on the network. The NMS needs to periodically poll the switches for information like interface status, CPU utilization, and memory usage. Which protocol and which action is used for this purpose? (Choose 2.)

NO.124 A Network Technician is observing a high number of late collisions and CRC errors on a switch port that is connected to an older hub. The port is configured for auto-negotiation. What Layer 1 issue is the most likely cause of these errors?

NO.125 Which of the following is a key feature of weighted fair queuing (WFQ)?

NO.126 Given IP address 172.20.3.54 and a mask of 255.255.255.0, what can be accurately stated about this addressing? (Select three)

NO.127 A Network Technician is connecting a new server to an HPE Aruba Networking CX switch using a Direct Attach Copper (DAC) cable.
What are the primary characteristics of DAC cables at the physical layer? (Select all that apply.)

NO.128 A Network Operator has just configured a new LACP-based Link Aggregation Group (LAG) between an access switch and a core switch. The LAG, `lag 1`, is composed of ports 1/1/47 and
1/1/48. The operator needs to validate that both physical links have successfully joined the aggregation and that LACP negotiation is complete.
The operator needs to answer the following questions:
* Is LACP enabled on the LAG?
* Are both member ports (1/1/47 and 1/1/48) successfully bundled?
* What is the operational state of the local and partner ports?
Which of the following validation commands provides the most direct and detailed output to answer all these questions?

NO.129 A Security Analyst is reviewing network traffic and needs to explain to a junior team member where encryption using TLS/SSL occurs.
At which layer of the OSI model does data encryption, session establishment, and management for protocols like TLS/SSL primarily take place?