HPE2-W09 HP
Rate this post

[Apr-2022] HPE2-W09 Dumps are Available for Instant Access using ExamsTorrent

HPE2-W09 Dumps 2022 – New HP HPE2-W09 Exam Questions

HP HPE2-W09 Exam Syllabus Topics:

Topic Details
Topic 1
  • Describe the benefits of VSX for a data center networking environment and implement VSX
  • Understand, describe and configure Datacenter Bridging (DCB)
Topic 2
  • Understand how to use NetEdit to simplify ArubaOS-CX device configuration
  • Understand the components of the ArubaOS-CX Switching architecture
Topic 3
  • Understand how to use the ArubaOS-CX Network Analytics Engine (NAE) to enhance monitoring and troubleshooting
  • Describe common data center networking requirements
Topic 4
  • Describe data center network design principles, including data center deployment models and the impact of various data center technologies on design

 

NO.26 Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) provides millions of IDs to scale for the needs of a multi-tenant environment

 
 

NO.27 Refer to the exhibit.
Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.

 
 

NO.28 Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.

 
 

NO.29 You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Idle, which means that the ring is up and fully connected with the RPL port blocked.

 
 

NO.30 The architect designs a spine and leaf network for a single data center that will use multiple leaf switches as Virtual Tunnel End Points (VTEP). The architect needs to select the type of Integrated Routing & Bridging (IRB) for the solution.
Is this statement about the IRB type true?
Solution: In the Asymmetric IRB egress VTEPs bridge the traffic to the destination networks.

 
 

NO.31 Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs’ processes.

 
 

NO.32 Is this a guideline for establishing a Virtual Switching Extension (V5X) Inter-Switch Link (ISL) between two ArubaOS-CX switches?
Solution: Use the same speed on every link In the ISL.

 
 

NO.33 Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site. Then combine multiple links between two data centers into VSX LAGs (M-LAGs).

 
 

NO.34 Is this a difference between a typical data center network’s requirements and a typical campus network’s requirements?
Solution: Data center networks are typically less oversubscribed than campus networks.

 
 

NO.35 Does this correctly describe how the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?
Solution: The ISL and keepalive goes down, and after a few seconds, the keepalive link restores. Switch-l and Switch-2 remains up. The Split-recovery mode is enabled. In this case the secondary switch shutdowns SVls when keepalive is restored.

 
 

NO.36 Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: In situations in which the primary switch fails and then reboots, you want to make the primary switch take over again as the primary switch.

 
 

NO.37 Refer to the exhibits.


Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10. except the incoming interface. It replicates the broadcast, encapsulates each broadcast with VXLAN. and sends the VXLAN traffic to 192.168.1.2 and 192.168.1.3.

 
 

NO.38 Refer to the exhibits.


Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.

 
 

NO.39 Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

 
 

NO.40 Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated configuration of Layer 3 MP-BGP protocol on leaf switches

 
 

NO.41 Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to help the switch to look inside tunneled traffic and apply different quality of service (QoS) settings to different types of traffic

 
 

NO.42 You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of seconds and is used to prevent frequent topology changes due to a link going up and down.

 
 

NO.43 An ArubaOS-CX is ssmq DCBX on Interface 1/1/1. You enter this command:
show dcbx interface 1/1/1
Is this where you can see whether the connected converged network adapter (CNA) has accepted the application priorities advertised with DCBX?
Solution: in the Enhanced Transmission Selection (ETS) Local advertisement section

 
 

NO.44 Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: extending Layer 2 communications between data centers that connect over Layer 3 MPLS links

 
 

NO.45 Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).

 
 

NO.46 You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Enable the REST interface in read-only mode.

 
 

NO.47 You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Make sure that the SSH server is enabled.

 
 

NO.48 Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A loopback interface

 
 

NO.49 Does this correctly describe NetEdit’s notification capabilities?
Solution: NetEdit notifies admins of errors using Its Internal email server.

 
 

HP HPE2-W09 Exam Practice Test Questions: https://www.examstorrent.com/HPE2-W09-exam-dumps-torrent.html

         

Related Links: www.callcentersindia.co.in myportal.utt.edu.tt myportal.utt.edu.tt buyerseller.xyz network.crcna.org myportal.utt.edu.tt

admin

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below